Table of contents: Removal ↓ Installation ↓
Oil pan
- 1. Oil dipstick
- 2. Sealing ring
- 3. Oil pressure sensor 0.3 bar
- 4. Oil pressure sensor 1.8 bar
- 5. Oil intake pipe
- 6. Dividing partition
- 7. Pallet
- 8. Bolt
- 9. Drain plug
- 10. Bolt
- 11. Flywheel cover
- 12. Washer
- 13. Rubber cover
- 14. Retaining spring
- 15. Bolt
- 16. Emphasis
- 17. Gasket
- 18. Bolt
- 19. Pallet gasket
- 20. Adapter
- 21. Valve
- 22. Oil filter
- 23. Filler cap
Removal
1. Raise and support the front of the vehicle.
2. Remove the dipstick and remove the lower engine shield.
3. Drain the oil.
4. Remove the front gearbox cover.
5. Rotate the crankshaft to access the rear oil pan bolts (arrows).
6. Secure the engine to the lift.
7. Remove the lower engine mount nuts.
8. Place a jack under the front suspension crossmember, remove the bolts and lower the crossmember slightly.
9. Remove the pan bolts.
10. Remove the tray.
Installation
1. Clean the surfaces of the oil pan and cylinder block and install a new gasket.
2. Installation is carried out in the reverse order of removal.
(The original text is available on the website: AUDIMANUAL.RU)