Open the hood.
Pull up the wire clip of the cap. Remove the cap.
Disconnect the wire tip from the extension cord connector.
Release and move aside the spring wire clip that secures the lamp holder.
Remove the lamp and install a new lamp so that the locking tabs on its flange fit into the grooves in the reflector.
Return the spring wire clip to its original position over the lamp base. Press the clip down.
Insert the cable plug into the connector block.
Place the cap in place so that its protrusions fit into the lower grooves of the headlight.
Press the wire staple.
Contact a specialist to check the installation of the headlights.
(The original article is available on the online resource: audimanual)