Sequence and tightening torque of cylinder head bolts (Audi A2)

Replace the cylinder head mounting bolts. Tighten the bolts in the sequence "1...10" in 4 stages as follows: tighten the bolts by hand until they stop. Tighten with a torque of 30 Nm. Tighten by 90° further. Tighten by 90° further.

[Read the original source on the website AudiManual]

The article was checked by auto expert Daniil Ushakov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Audi A2: Engine repair

Cylinder head — design description
Removal and installation the flywheel
Replacing the crankshaft seal
Engine speed sensor

Removal and installation of the cylinder head
Camshaft housing — design description
Intake camshaft gear with variable valve timing
Replacing the cuff for the intake camshaft gear