Removal and installation a poly V-belt pulley without a freewheel mechanism (Audi A2)

Table of contents: Removal ↓ Installation ↓

Removal

Remove the generator. If present, remove the protective cover on the generator pulley. Hold the fastening nut with the "3310" attachment and turn the generator shaft clockwise. Remove the poly V-belt pulley.

Installation

Installation in reverse order, taking into account the following: to tighten, turn the generator shaft counterclockwise. Install the protective cover on the generator pulley. Tightening torque: Belt drive pulley to the generator: 65 Nm.

The original version of the article is posted on the website: Audimanual.ru

The article was checked by auto expert Daniil Ushakov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Audi A2: Power devices

Checking the brushes — all Bosch generators since 2001
Removal and installation the relay-regulator (Bosch since 2001)
Bosch generator manufactured since 2001
Bosch generator produced before 2000

Removal and installation a poly V-belt with an overrunning clutch
Removal and installation the starter (1.6 liter FSI engine)
Removal and installation the starter (1.2 liter TDI engine)
Removal and installation the starter (1.4 liter TDI engine)