Table of contents: Removal the headlight housing mount ↓ Installation ↓
Bracket, mount and headlight housing 1. Holder for fixing the headlight housing; 2/3. Bolt. 8 Nm; 4/6/7. Bolt. 4.5 Nm; 5. Bracket; 8. Headlight housing mount; 9. Bolt; 10. Front Airbag Impact Sensor; 11. Bolt. 1.2 Nm; 12. Headlight washer nozzle
Removal the headlight housing mount
Turn off ignition. Removing headlight housing: halogen headlights. Unscrew bolts "3, 5, 7" and remove bracket "4". Unscrew bolt "2" by 3 turns and press fastening "6" from headlight housing "1" forward.
Installation
Insert the headlight housing all the way down into the headlight housing mount. The headlight housing should easily and effortlessly enter its mounting socket. Place the headlight housing "3" with the bracket on the radiator frame and wing arch. Tighten the bolts "1,2,4,5" tightly.
The guide nose "arrow B" on the bracket "1" of the headlight housing must enter the groove of the radiator frame "3". Guides "2" and "4" must enter the fasteners "arrow A".
Install the front bumper trim. Set gaps "1" to the contours of the body. Gap size = gap uniformity. Tighten bolts "2...7", installing the headlight housing flush with the outer edge of the wing. Remove the front bumper trim.
Tighten the bolts "1, 2, 4, 5". Install the front bumper trim.
Check the gaps again, if necessary, repeat the gap adjustment as described at the beginning. Adjust the position of the headlights.
This publication is borrowed from the resource AudiManual.ru