Table of contents: Removal ↓ Installation ↓
Removal
The engine must be cold. Remove the engine hood. Open the coolant expansion tank cap briefly to release residual pressure in the cooling system.
Unscrew the water collector "1" and put it aside together with the connected drain hose "2". Disconnect the plug connector "1" of the coolant temperature sensor "G62".
Remove retainer "2" and coolant temperature sensor "G62".
Installation
Installation in reverse order, it is necessary to replace the gasket and sealing ring. In order to avoid coolant loss, immediately insert a new coolant temperature sensor "G62" into the pipe. Check the coolant level.
This article was copied from the website AUDIMANUAL.ru