1. Rear seat belt. Remove the rear screen trim. Remove the rear bench seat. Unlock the cover "2" of the wheel arch trim. Remove the wheel arch trim. Remove the boot floor trim. Remove the boot trim. Remove the sound insulation. Unscrew the screw "5". Unscrew the screw "8". Remove the seat belt "1" forward with the twist stop "10". Installation: connect the seat belt as shown in the enlarged view, with the twist stop "10". Arrow "A" indicates the direction of travel. Installation in reverse order. After installing the three-point seat belt "1", check the operation of the child seat belt
2. Overlay
3. Clamps
4. Tightening pad. Screw in place of thickening with a stop from twisting
5. Bolt. Tightening torque 55 Nm
6. Belt guide console. Unscrew screws "7" (3 pcs.). During installation, observe the tightening sequence of screws "7": "A", "B", "C" or "B", "A", "C"
7. Bolts (3 pcs.). Tightening torque 24 Nm
8. Bolt. Tightening torque 55 Nm
9. Soundproofing
10. Anti-twisting stop
Lower attachment point
Unlock cover plate "1" using clamp "2" from clamping device "3". Unscrew screw "7" (tightening torque 55 Nm). When installing, the tightening pad "6" should snap into place in the thickening from the rotation "5". 4. Rear wheel arch trim.
(The original publication in its entirety is posted on the website: AUDImanual)