Removal and installation the oil pressure sensor (Audi A2)

Table of contents: Removal ↓ Installation ↓

Removal

Remove the engine hood. Disconnect the "arrow" connector of the oil pressure sensor "F1". Place a rag underneath to collect the leaking oil. Unscrew the oil pressure sensor.

Installation

Installation is in reverse order, in this case it is necessary to replace the sealing ring. Check the oil level.

The article was checked by auto expert Daniil Ushakov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Audi A2: Lubrication system

Removal and installation the oil pump
Removal and installation the oil pan
Oil level and temperature sensor
Oil pressure sensor

Similar articles on other Audi car models:
Fuel level sensor — removal and installation Audi 80 B3 (1986-1991, petrol)
Coolant Temperature Sensor — Removal and Installation Audi 100 C3 (1982-1990, diesel)
Removal and installation the fuel pump / fuel level sensor Audi A3 Type 8L (1996-2003)
Tire pressure sensor — removal and installation Audi A4 B8 (2007-2015)
Speedometer sensor — removal and installation Audi A6 C5 Allroad (1999-2005)
Removal and installation the engine Audi A8 D2 (1994-2002)
Removal the oil pressure sensor Audi Q5 Type 8R (2008-2017)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

Audi A2(1999-2005)