Table of contents: Removal ↓ Installation ↓
Removal
Lift the carpet in the driver's side footwell and remove the "arrow" trim.
Disconnect and freely place the connector for the lambda probe after the "G130" catalytic converter.
Remove the noise-insulating casing, loosen the fasteners "arrow" for this. Unscrew bolts "1" and "2". Cut the cable tie "3". Unlock the clamps "arrow" and remove the wiring. Lay the engine wiring harness on the body.
Remove the wire for the lambda probe after the catalytic converter "G130" from the rubber tip "arrow to the left" and unclip it from the heat shield "arrow to the right". Unscrew 2 bolts for the heat shield and freely lay the wire for the lambda probe after the catalytic converter "G130".
Unscrew the "arrow" bolts and remove the heat shield.
Loosen the threaded connections "arrows" for the clamping sleeve.
Protect the detachable element from bending with the "T40035" clamp.
Unscrew the bolts "arrows" securing the exhaust pipe to the exhaust manifold. Remove the exhaust pipe with the catalytic converter and resonator from the mounting cables and set aside.
Installation
Installation is in reverse order, in this case it is necessary to install the heat shield. Install the soundproofing screen.
(Read the original source on the website «AUDImanual.ru»)