Removal and installation the EGR valve (Audi A2)

Table of contents: Removal ↓ Installation ↓

Removal

Unscrew the "arrow" bolts for the exhaust manifold pipe.

Disconnect connector "3". Unscrew the nuts "arrows", remove pipe "1" for the EGR system, EGR valve "N18" with EGR potentiometer "0212" "pos. 2".

Installation

Installation is in reverse order, in this case it is necessary to replace the gaskets.

The article was checked by auto expert Daniil Ushakov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Audi A2: Exhaust system

Exhaust Gas Recirculation System — Design Description
Removal and installation the exhaust manifold
Exhaust manifold — design description
Removal and installation the inlet pipe with the catalytic…

Similar articles on other Audi car models:
Removal, installation, testing of cold start valve (K-,… Audi 80 B3 (1986-1991)
Fuel cut-off valve — removal and installation Audi 100 C3 (1982-1990, diesel)
Removal and installation the lower engine compartment cover Audi A3 Type 8L (1996-2003)
Removal and installation the cylinder head, its cover and the… Audi A4 B7 (2004-2008)
Removal and installation valve injectors Audi A6 C4 (1994-1997)
Removal and installation the engine Audi A8 D2 (1994-2002)
Turbocharger — removal and installation Audi Q5 Type 8R (2008-2017)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

Audi A2(1999-2005)