Table of contents: Removal ↓ Installation ↓
Removal
Disconnect the multi-pin plug connector of the pump-injectors and glow plugs by removing the release pin "arrow 1" and loosening the knurled nut "arrow 2". Remove the cylinder head cover.
Remove the pump-injector plug connector using the "arrow" screwdriver. To avoid distortion, support the opposite side of the plug connector by pressing lightly with your finger.
Unscrew the multi-pin plug connector from the Strelka cylinder head and push it out of the hole.
Remove the wiring harness "2" with plug connectors "1" from the cylinder head, releasing the clamps.
Installation
Remove the clamps "2" from the new wiring harness. To facilitate installation of the wiring harness, insert the connectors "1" into the mounting guides.
Insert the wiring harness "2" from the bottom right - the cylinder head opening. In this case, the wiring harness must be laid in such a way that the plug connectors "1" of the unit injectors are located as shown in the figure. Install the clamps and bring the wiring harness to the installation position. Tighten the multi-pin plug connector. Connect the plug connectors of the unit injectors. Installation in the reverse order, in this case, it is necessary to remove the cylinder head cover. Tightening torque: Multi-pin plug connector to the cylinder head: 10 Nm.
