Withdrawal
With a cold engine, remove the engine cover. Briefly open the cap on the coolant expansion tank to relieve residual pressure in the cooling system. Unscrew water trap -1- and lay to one side with connected drain hose -2-.
Unscrew bolts -arrows- and move pipe -1- for exhaust gas recirculation slightly upwards.
Unplug electrical connector -1- for coolant temperature sender -G62-.
Remove retainer -2- and coolant temperature sender -G62-.
Installation
Install in reverse order, replacing gasket and seal. ring. To prevent loss of coolant, insert a new coolant temperature sender -G62- into the connection. Install pipe for exhaust gas recirculation. Check coolant level.
Visitor comments