Withdrawal
Drain coolant. Remove toothed belt. Release screws -1- and remove coolant pump -2-. Remove seal. ring -3-.
Installation
Install in reverse order, but the seal must be replaced. ring. Clean or deburr the seating surface of the seals. rings. New seal. moisten ring -3- with coolant concentrate "G12+". Install coolant pump -2-. Mounting position The plug on the housing points downwards. Install toothed belt (by adjusting the valve timing). Fill up the coolant. Tightening torque: Coolant pump to cylinder block 15 Nm.
Visitor comments