Table of contents: Disconnecting the flexible cable ↓ Tweeter Plug Connector ↓ Window lifter control unit connector ↓ Door trim fastening clip ↓
1. Door trim. Using a flat-head screwdriver, press out the tweeter screen "2". Unscrew the bolt "3". Unscrew the bolts "4" (2 pcs.) from the door trim. Release the door trim "1" from the clamps "7" (8x) of the door base. Press the door trim "1" upwards from the supporting profile "6". Disconnect the flexible cable of the inner door handle. Disconnect the tweeter plug connector. Disconnect the window lifter control block connector. Installation: Replace damaged clamps "7". Secure the wire sets. Tighten the Bowden cable. Tighten the door trim "1" on the retaining profile "6". Lock the door trim "1". Secure the door trim "1" with screws
2. Tweeter screen
3. Bolt. Tightening torque 2 Nm
4. Bandages (2 pcs.). Tightening torque 2 Nm
5. Door body
6. Retaining profile
7. Clips (8 pcs.)
Disconnecting the flexible cable
Remove cable "1" from guide "2" and disconnect it. When installing, make sure that hook "3" is facing upwards.
Tweeter Plug Connector
Carefully press the clamps "2" in the direction of arrow "B". Pull the plug connector "3" in the direction of arrow "A" away from the high-frequency speaker "1".
Window lifter control unit connector
Fold back the lock "2" (in the direction of the arrow). Pull out the plug connector "3" from the window lifter control unit "1".
Door trim fastening clip
Press the locking tab "2" and remove the clip "1" in the direction of the arrow.
[The original article is available on the website: AudiManual.ru]