Fig. 1–9. Location of window lift switches in the driver's door armrest: A – driver's door; B – front passenger door; C – right rear door; D – left rear door; S – safety switch
The switches are located in the driver's door armrest (Fig. 1–9).
In addition, additional switches for the corresponding windows are located in the front passenger door and in the rear doors.
Using a safety switch S in the driver's door, you can turn off the electric drive of the rear windows.
Safety switch positions:
- safety switch unlocked, rear door switches functional;
- the safety switch is locked, the switches in the rear doors and the rear cigarette lighter are disabled.
Electric windows with automatic window closing control are equipped with overload protection.
The window closing is automatically stopped when an obstacle is encountered in the glass's path. However, this does not happen when the windows are closed from the outside using the ignition key - the overload protection does not operate.
Operation of window lifts with ignition on
Opening
When you press the corresponding switch in front (driver's door) or on the bottom of the switch (right front and rear doors) and holding this position for a short time, the window opens completely (the glass goes down automatically).
When you press the switch again, the glass stops immediately.
Automatic window closing (front doors)
When the front part is raised briefly (driver's door) or by pressing the top part (right front door) the corresponding switch closes the window completely (the glass rises automatically).
When the switch is pressed again, the glass stops immediately.
Rear door window lifts are equipped with an automatic window lowering device only. To close the window, hold the switch until the desired glass position is reached.
Note: After disconnecting and then reconnecting the vehicle battery, the automatic window opener for the front doors will no longer function.
In order to restore the operation of the automatic device, it is necessary:
- raise the windows with electric windows up to the stop;
- press all window switches again for at least 1 s to the closed position to activate the window control unit.