Lubrication system:
1. Bolt, 10 Nm
2. Oil level and oil temperature sender -G266-
3. Sealing cuff. Replace
4. Oil pan
5. Oil drain plug, 30 Nm
6. Bolt, 10 Nm
7. Suction pipe, clean strainer if dirty
8. Bolt, 10 Nm
9. Seal. Replace
10. Bolt. Replace, 12 Nm
11. Crankshaft seal. Replace
12. Oil pump. The oil pump housing is a sealed assembly. flange on the side of the belt pulley, before installation, check whether both fitted bushings for centering the oil pump/cylinder block are present, when installing, observe the hub of the driven disk on the crankshaft
13. Seal. Replace, must be mounted on centering sleeves
14. Cylinder block
15. Oil filter
16. Bolt
17. Bolt. Renew, use socket wrench -T10058- to unscrew and tighten on flywheel side
Visitor comments