Withdrawal
Switch off the ignition and remove the ignition key. Set the light switch to position "0". Remove the hood. Unlock wire clip -arrow and remove housing cover -1- from headlight housing.
Unplug connector -2- at headlight range control motor. Turn control motor -1- at left headlight clockwise and right headlight counterclockwise -arrow- until it is horizontal. Swing the ball head of the adjusting axle down from the mounting in the reflector. Remove the veil corrector actuator from the headlight housing.
Installation
Installation is in the reverse order, while it is necessary to push the ball head of the adjusting axle into the mount on the reflector and turn the actuator until it stops in the installation position. Close the housing cover. Secure the housing cover with a wire clamp. When removing or installing, as well as replacing the actuator, the headlights must always be adjusted.
Visitor comments