Replacing the high beam bulb (Audi A2)

Turn off the ignition and remove the ignition key. Set the light switch to position "0". Remove the hood. Unlock the wire clamp "arrow" and remove the housing cover "1" from the headlight housing. Turn the actuator motor "4" of the left headlight corrector clockwise, and the right headlight counterclockwise "arrow" so that it is horizontal. Disconnect the connector "3" of the high beam incandescent lamp.



Unclip the wire fastening clips "1" and remove the incandescent lamp "2" from the housing.

Installation is in reverse order, in this case it is necessary to install a new incandescent lamp in the housing, while not touching the glass bulb of the lamp with bare hands. Fix the incandescent lamp with a wire fastening clip. Reconnect the plug connector and close the housing cover. Fix the housing cover with a wire clip.