Removal and installation the diagnostic plug of the security systems (Audi A3 8L)

Table of contents: Removal ↓ Installation ↓

Removal

1. Remove the diagnostic connector cover.

2. Use a screwdriver –1– to pry up the 3 stoppers (arrows) on the diagnostic plug –2–.

3. Remove the diagnostic plug.

Installation

1. Replace the diagnostic plug. It should click into place.

2. Install the plug cover.

(The article was copied from the website «AudiManual.ru»)

The article was checked by auto expert Nikita Rudakov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Audi A3 Type 8L: Interior (internal elements)

Removal and installation the lower center console
Removal and installation the armrest
Removal and installation interior mirror
Caring for upholstery and carpets

Removal and installation the center console
Removal and installation the A-pillar trim
Removal and installation the pocket on the driver's side
Removal and installation the glove box

Similar articles on other Audi car models:
Engine — removal and installation Audi 80 B3 (1986-1991, petrol)
Toothed drive belt — removal, inspection and installation Audi 100 C3 (1982-1990, diesel)
Security System Components — Removal and Installation Audi A4 B5 (1994-2001)
Removal and installation the timing belt — Diesel engine… Audi A6 C5 (1997-2004)
Removal and installation the engine Audi A8 D2 (1994-2002)
Turbocharger — removal and installation Audi Q5 Type 8R (2008-2017)
Removal and installation the switch to deactivate the interior… Audi A2 (1999-2005)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet