Door lock actuator
Removal
1. Remove the beam, refer to the subsection Removal and installation the front door and adjusting element holder and to the illustration.
2. Remove the door lock cover, refer to subsection Removal and installation the front door handle and lock cylinder.
3. Disconnect the drive and locking rods, refer to subsection Removal and installation the front door handle and lock cylinder.
4. Disconnect the single lock vacuum hose.
5. Disconnect the cable (4A).
6. Remove screws –1–.
7. Remove the door lock –3– with the lining –2–.
Installation
1. Replace the lock –3– with the washer –2–. Tighten the screws –1– to 10 Nm.
2. Connect the cable. Fragment (4B) shows the cable connected.
3. Connect the locking and drive rods, as well as the door lock cover, refer to subsection Removal and installation the front door handle and lock cylinder.
4. Install the beam, refer to the subsection Removal and installation the front door and adjusting element holder.
Tailgate Activator
Removal
1. Remove the tailgate trim, refer to subsection Removal and installation the tailgate trim.
2. Press out the pins (arrows) and remove the actuator –1– from the tailgate lock. Use a screwdriver if necessary.
Installation
Installation is performed in the reverse order of removal.
Fuel filler flap actuator
Removal
1. Remove the rear light, refer to the subsection Removal and installation the rear light.
2. Disconnect the connector, refer to the subsection Single Lock - General Information and Vacuum Hoses.
3. Through the window (arrow A) on the back side, release the locking mechanism of the drive element –1– and remove it.
Installation
1. Place the drive element in place and secure it.
2. Insert the angled plug into the drive element.