Withdrawal
Drain the coolant.
Pic. 3.4–3. Location of the clamps for fastening the cooling system hoses to the heater fittings on the bulkhead of the engine compartment
Loosen the clamps (see fig. 3.4–3) and disconnect the coolant hoses going to the heater.
Pic. 7-30. Arrangement of bolts of fastening of the left average pipe of the cooling system of the diesel engine 3,3 l
Unscrew the bolts and remove the left middle pipe of the cooling system (pic. 7–30).
Installation
Installation is carried out in the reverse order of removal, taking into account the following.
Clean the O-ring seat before installation.
Install a new O-ring after lubricating it with coolant G 012 A8 D.
Fill with coolant.
Visitor comments