3-door models
Removal
1. Remove the side trim from the rear, refer to subsection Removal and installation rear side trim.
2. Loosen the screws securing the lugs –3– and remove them.
3. Remove cover –1–.
4. Remove screws –2–.
5. Remove the rear roof trim, refer to subsection Removal and installation the rear roof trim.
6. Detach the trim –4– at the rear and pull it forward out of the clamp.
7. Disconnect the connector and remove the trim.
Installation
1. Replace the trim –4– and connect the connector.
2. Insert the trim into the clamp and secure it.
3. Install roof lining, refer to subsection Removal and installation the rear roof trim.
4. Secure the trim –4– with screws –2–.
5. Install and secure the cover.
6. Secure the lugs –3–.
7. Install the side trim at the rear, refer to subsection Removal and installation rear side trim.
5-door models
Removal
1. Remove the trunk mat.
2. Remove 4 screws –7– and remove lugs –6–.
3. Remove the rear entry plate, refer to subsection Removal and installation the threshold strip.
4. Remove the rear seat back, refer to subsection Removal and installation the rear seat and backrest.
5. Detach the rear wheel housing trim and remove it.
6. Remove the trunk side trim cover –2– or –3–.
7. Remove rivet –4– and unscrew screw –5–.
8. Detach the trim –1– at the rear and remove it from the C/D– pillar trim.
9. Remove the front trim –1– from the seat back clamp.
10. Disconnect the trunk light connector and remove the trim.
Installation
Installation is performed in the reverse order of removal.
The original article is available on the online resource AUDImanual.ru