Withdrawal
Switch off the ignition and remove the ignition key. Set the light switch to position "0". Remove lid from luggage compartment side trim -arrows-.
Disconnect connector -1-. Press catches -arrows- and pull bulb holder -2- towards vehicle interior out of rear light.
Remove nuts -arrows-. Pull the rear light out.
Installation
Install in reverse order, making sure that the seal between body and rear light housing is clean. Before tightening nuts -arrows- align rear light to body contours. At the same time, ensure uniform gaps. Tightening torque: Rear light to body: 4.5 Nm.
Visitor comments