Withdrawal
To remove the glove box lock cylinder, use a screwdriver with a diameter of 1.6 and a length of 40 mm.
Remove glove box and place it in the passenger's footwell.
Pic. 16–41. Key position and location of the screwdriver hole when removing the glove box lock cylinder
Insert and turn 45°the key in the glove box lock cylinder (pic. 16–41).
Pic. 16–42. Using a screwdriver to release the glove box lock cylinder
Insert a screwdriver into the hole to release the lock cylinder and, while pressing the screwdriver upwards, remove the glove box lock cylinder with the key inserted (pic. 16–42).
Pic. 16–43. Loosening the Phillips Head Bolt Through the Lock Cylinder Hole
Through the hole for the lock cylinder, loosen the cross-head bolt until the latches move back, and remove the locking mechanism forward (pic. 16–43).
Pic. 16–44. An arrangement of a nut with a knurling of fastening of a cable of the lock of a ware box
Turn the knurled nut on the cable fastening, disconnect the cable from the lock of the glove box and remove the lock (pic. 16–44).
Installation
Installation is carried out in the reverse order of removal, taking into account the following.
If glove box does not close properly, adjust the cable length with the adjusting nut.
Visitor comments